Hoop on plate.
Pack of 2.
The backing plate is 25.4mm wide and 8mm high.
The hoop is D-shaped - 12mm at the widest point and 19mm high (outside dimensions).
The plate has pre-drilled holes approximately 1.7mm diameter.
Use pins GA30007 or GA30008 (see below).
Use Tacky wax or similar to hold in place while fixing. Using an awl or drilling a small pilot hole will make the job easier. None of the screws we stock are small enough. The inside of the plate is concave, so mechanical fixing will be the most secure.
Using adhesive may seep into the part which hold the loop, stopping its ability to move. It will otherwise move 180°.
Suitable as handles for drawers or doors. Also as hanging loops.