Model Making Materials

+44 (0)20 7264 1288

RECENTLY VIEWED

Dungeon plunger to cut and imprint textured and plain tiles
Making Keramistone bases
Making Keramistone bases
Making Keramistone bases
Making Keramistone bases
Dungeon plunger set - 32mm bricks
Dungeon plunger set - 32mm cobblestone
Dungeon plunger set - 32mm plain
Dungeon plunger set - 25mm bricks
Dungeon plunger set - 25mm cobblestone
Dungeon plunger set - 25mm plain
Dungeon plunger set

DUNGEON PLUNGER SET (MW40000)

£12.25 inc.VAT
C&C available
Quantity

Dungeon plunger set.

This set will allow you to cut and imprint textured and plain tiles of up to 3mm thickness, to be used in your miniature bases and Dungeon tiles - we tested the plungers on Keramistone.

Cutters for 25mm gaming (1:76) are 25mm square, 32mm (1:57) square for 32mm gaming.

 

Set comprises 1 each of:

  • Bricks for 32mm gaming
  • Cobblestone for 32mm gaming
  • Plain for 32mm gaming
  • Bricks for 25mm gaming
  • Cobblestone for 25mm gaming
  • Plain for 25mm gaming

 

Directions

Roll out your clay (Keramistone, air drying, polymer or Newplast) to 3mm thick. The easiest way to do this is to lay your clay between 2 planks or strips 3mm thick, within the width of your rolling pin. This means you won’t roll thinner than 3mm.

It is possible to make tiles which are thinner than 3mm. To get the texture you’ll have to press the cutter into the clay, then press further into the cutter. The plunger action will then pop it out.

Clean off any excess material to keep your imprints crisp.

4D Model Shop uses cookies to help ensure your experience on our site is the best possible. Click here to read our Privacy Policy.
Please check the box to accept and close